Page: 13 / 15
6.13 Alarm event history:
Command: x
Description: x = (0-9) press key 0~9 to inquiry the latest 10 alarm events and display alarm defense area (0
means the most recent event).
6.14 Telephone line tampering detection:
Command: *51* Description: the system will alarm when telephone lines disconnect or failure
Command: *50* Description: the system will not detect telephone lines disconnection or fault.
7. Remote Controller (Key fob) Description
7.1. Set up Arm
Press “ ”button on the remote controller, and the LED display “SF”, means system “Armed”.
7.2 Set up Disarm
Press “ ” button on the remote controller, and the LED display “CF”, means system “Disarmed”.
7.3. Emergency Alarm
Press “ ”button on the remote controller for emergency help, And the LED display “99”.
Press“ ”button on the remote controller one time is silent alarm, while press “ ”button twice or long time the
siren will sound.
7.4. Intelligent Arm
Press “” button on the remote controller and the LED display “bF”, means system “Intelligent Armed”.
8. Remote Control the system:
You can use any telephone to dial the numbers of the system and it will put on automatically get through
after system detecting the ring times you have been setup. When you hear the beep, input passwords
(two sounds when the password is wrong, if the password input wrongly 3 times or no any operations
within 20 seconds the phone will hang up automatically) and if it is correct, you can have remote
control of the system, press # after accomplish all operations, then you can implement other
operations and hang up telephone.
Press “1” to monitor (Press “1” again for monitor 20 seconds more.)
Press “2” to start the siren
Press “3” to stop the siren
Press “4” to arm
Press “5” to disarm
Press “#” to affirm and hang up
9. Handing Incoming Alarm Phone Calls
When sensors are triggered or emergency help, the alarm panel will dial up the setup telephone numbers
automatically and give alarm rings based on settings. If the host’s phone is in use or not able to connect, the
system will dial next alarm phone, until it is dialed and hosts confirm. It will play records after receiving alarm
phone and the operation methods are similar to remote setup.
10. Reset Factory Settings
Command:*80000*
Description: 0000 is default password (All settings will be cleared except all the registered sensors)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales