
Page: 17 / 17
9. Remote Control the system:
You can use any telephone to dial the numbers of the system and it will put on automatically get through after
system detecting the ring times you have been setup. When you hear the beep, input passwords (two beep
sounds if the password is wrong, if the password input wrongly 3 times or no any operations within 20
seconds the phone will hang up automatically) and if it is correct, you can have remote control of the system,
press # after accomplishing all operations, then you can implement other operations and hang up telephone.
Press “1” to monitor (Press “1” again for monitor 20 seconds more.)
Press “2” to start the siren
Press “3” to stop the siren
Press “4” to arm
Press “5” to disarm
Press “6” to play the recorded personal voice message
Press “7” to open 12V output
Press “8” to close 12V output
Press “9” to close the speaker (External)
Press “0” to open the speaker (External)
Press “#” to affirm and hang up
10. Handing Incoming Alarm Phone Calls
When sensors are triggered or emergency help, the alarm panel will dial up the setup telephone numbers
automatically and give alarm rings based on settings. If the host’s phone is in use or not able to connect, the
system will dial next alarm phone, until it is dialed and hosts confirm. It will play records after receiving alarm
phone and the operation methods are similar to remote setup.
11. Reset Factory Settings
Command:*80000*
Description: 0000 is default password (All settings will be cleared except all the registered sensors)
12. Copyright and Disclaimer
Copyright © 2014VT TECH Corp. All rights reserved.
The user manual may be changed without prior notification.
This user manual, or any part thereof, may not be reproduced for any purpose whatsoever without the written
authorization of VT TECH Corp., or transmitted in any form, either electronically or mechanically, including
photocopying and recording.
In no event shall VT TECH Corp be liable for direct, indirect, special, incidental, or consequential damages
(including but not limited to economic loss, personal injury, and loss of asset and property) arising out of the
use or inability or illegality to use the product or documentation.
If you encounter any problems when using our products, and cannot solve them by yourself, please contact
our technical support team by writing an E-Mail to support@vttech.com.
Comentarios a estos manuales