
Page: 8 / 17
SP+ Connect speaker anode
SP- Connect speaker negative
Connect wired zones COM port / Output DC12V negative
L1 Wired zone 1, connect wired sensors NC or NO port
L2 Wired zone 2, connect wired sensors NC or NO port
OUT
It is a can be programmed to control the output of the
DC12V
DC12V output, It can supply power for wired sensors
5.4 Connecting and Installation
Read this manual before using your VT-G992E and check if all parts are included in the packaging box.
4.4.1 Ensure that your VT-G992E has a 2G working SIM installed.
Before inserting SIM card, cut off the power for VT-G992E.
Install SIM Card
- Open the SIM card cover at the back of VT-G992E.
- Insert the SIM card by sliding it into the card slot with the chip
module facing to the connectors on PCB.
- Put back the SIM card cover.
- Check that the SIM has not run out of credit (test the SIM in a phone
to make sure it can call succeed)
- Check that the SIM Lock code is turned off
- If you require the function of sending an SMS to the mobile phone
number when it makes a alarming, please make sure the SIM card
have balance and the message function.
Check that the MOBILE LED is flashing 1 second on and 3 seconds
off.
If the MOBILE LED still light or the LED screen shows F4, please turn
off the power, check the SIM slot or GSM antenna and then turn on
again
Comentarios a estos manuales